I added the AP as a client with and have tried using both RADIUS Standard and Cisco as the RADIUS type.I configured the IAS policy to grant access to Domain Computers, Authentication is set to PEAP and uses a private cert issued by our CA, the other profile settings are all default.I recently bought a new Linksys wireless router and after setting it up with basic WEP security, I tried to logon from my laptop and was successful! So then I tried to connect from my desktop computer that has a wireless USB adapter attached to it and I ended up getting this error message: Fabulous! I checked my settings on the wireless router to make sure I didn’t accidentally setup certificate security, but found no such thing.
If multiple clients are unable to connect, follow instructions in our wireless network troubleshooting tip to debug probably AP or router or upstream network problems.
Otherwise, proceed to step 2 to debug the affected Android client. Before going any further, make sure that your Android device's Wi-Fi radio is not in Airplane Mode and that Wi-Fi is on and ready to connect.
I moved the selection tab to WPA2 only and keep the rest the same and no luck.
I cannot get WPA2 enterprise to work on my network. Windows Domain, using IAS and its own CA Linksys WAP200 Access Point I setup the AP to use WPA2-Enterprise Mixed using RADIUS I setup and registered IAS on the domain controller.
After about 30 minutes of fiddling around with various settings, I was able to figure out what the problem was.
Here’s how to connect to your wireless router if you are getting this message.
The role of teacher is often formal and ongoing, carried out at a school or other place of formal education.
In many countries, a person who wishes to become a teacher must first obtain specified professional qualifications or credentials from a university or college.
If the box was checked, then that was why you were getting the “unable to find a certificate to log you on to the network” message because Windows is looking for one, but your wireless router is not setup for certificate security. Once I unchecked that box and tried to reconnect to the wireless network, everything worked fine!
Ok so I setup the router to only transmit wireless N and to use WPA2 only.
When status is Connected, tap Advanced to view the client's assigned IP address.